Christie HAL Series User Manual page 60

NOTE: System messages appear only if the
is set to or
A system warning message indicates that a system malfunction has been
detected (see Status LED Codes, below). A system warning message replaces
any input signal message and disappears when the input signal status changes.
While the projector will remain operational, the message indicates the presence
of a serious problem that should be reported to the factory. You can press
to remove the message, but for best results you should reset the projector—
power the projector down and up again with the
A system error message indicates that a serious malfunction has been detected
and must be reported to the factory (see Status LED Codes, below). The
projector will no longer operate and must be reset—power the projector down
and up again with the
If the "Status" LED on the back of the projector repeatedly flashes a pattern of
yellow and red light while the "Power" LED glows a continuous red, you have
encountered a possible system error requiring the attention of a qualified service
technician (see System Warnings and System Errors, above). Please contact your
dealer or Electrohome if the problem persists.
The specific pattern of flashing indicates the 2-digit type code identifying the
type of problem detected — the number of yellow flashes represents the first
digit and the number of red flashes indicates the second. For example, a pattern
of "yellow-yellow-red" is "Code 21", meaning that the lamp has overheated.
Possible codes and what they mean are shown in Table 3-2:
12 Software bug
13 CRC error in flash ROM
14 Programming complete
21 Lamp has overheated
22 Unable to turn lamp on
31 SCM not clearing the busy line
32 Unable to set host ID (SCM)
33 SCM failed to reply to a request
Please contact your dealer or Electrohome if an error code persists.
key.
Table 3-2. System Error Codes
41
51
52
61
71
72
73
OPERATION
in the Preferences menu
key.
ACM doesn’t return I C
acknowledgments
Unable to access EEPROM on
the ICM
EEPROM has reinitialized (ICM or
VCM)
Unable to access the PIM
Boot code CRC failed
Unable to program Xilinx (on
VCM)
Unrecognized ROM type
DLV 1280
User's Manual
3-35