Table of Contents
Advertisement
3.6
Adjusting the
Image
Slot numbers for other switchers can range from 1-9. Edit as necessary.
Select "
Select "
menu that may appear when you press
from appearing in the channel selection list.
Select "
switch to or away from this channel when the input signal changes
(recommended).
Read-only, showing the type of signal for which this channel is
defined, such as "Composite."
polarity ("pos" or "neg") for a channel. These numbers enable selection of the
correct channel setup for the current source. If these are blank, there is no sync
present or detectable.
Select this option to reset all image parameters for the current channel
to their defaults. This is useful if you specifically wish to re-define a channel
according to default values or if you want to change the source for a channel. A
message of "reading New Values" appears on screen during an update.
Various image controls lie in three function menus: Image Settings, Horizontal
Settings or Vertical Settings, each of which is called up by its own name in the
Main menu. Or, if desired, call up an individual image control directly from
presentation level by pressing the
representing the numbered menus and options you want.
While in any of the function menus (each described below), you can adjust
settings for the current image by working with the available slidebars, on/off
options and pull-down lists. When you are done with a function menu, press
to accept changes and return to the previous menu.
Use this menu to adjust all settings for the current image except its size and
position. In Image Settings, adjust brightness, contrast, color, tint, or color
temperature as well as its video standard and others. Refer to Using Slidebars
and Other Controls if you need help in selecting options and accepting changes.
" to prohibit any changes to the channel, "
" if you want this channel to appear in the channel selection
" (default) if you want the projector to automatically
These read-only parameters show the frequencies and
key followed by the appropriate numbers
OPERATION
" to unlock.
. Select "
" (default) to prevent it
DLV 1280
User's Manual
3-19
Advertisement
Table of Contents
