Christie HAL Series User Manual page 53

OPERATION
3-28
DLV 1280
User's Manual
portion of the Service menu is password-protected and can be used by qualified
service personnel only. See below:
In the Service menu, select
from presentation level, press
one pattern to the next (press
press , or cycle out with
Whenever you install a new lamp in the projector you need to record the lamp
Figure 3-18. Lamp Menu
shows the number of hours logged on the current lamp. Whenever
a new lamp serial number is recorded, this value automatically resets to "0",
where it begins to log time for the new lamp.
Set to "
power-up that the lamp has reached the specified lamp limit and should be
replaced. Set to " " if you do not want to see this warning—instead, when your
Figure 3-16. Service Menu
for a pull-down list. Or, for quick access
. Continue to press
if you have paused). To leave test patterns,
.
Figure 3-17. Test Pattern Options
serial number in the projector's
memory. Once installed, you can set
different options for the lamp such as
its intensity and expected life span.
These setups can be changed at any
time during the life of the lamp.
NOTE: See 4.4, Replacing the Lamp
and Filter for complete instructions on
installing a new lamp in the projector.
In the Service menu, select "
access the Lamp submenu (see left).
" if you want to enable a warning message upon
to quickly go from
" to