Loosen the four screws located in the
corners of the projector lid. Lift off
the lid and set aside (Figure 4-2).
(lid: where applicable)
Locate the lamp assembly—consisting of a metal lamp bracket attached to the
lamp module—installed near the center-left of the projector's interior. Locate the
4 corner screws securing the complete assembly to the projector: the 2 rear
screws are on the bracket flange, the 2 front screws are located under the flexible
U.V. Light Shield and are accessible through holes in the bracket (beneath the
shield). Puncture/cut the U.V. shield as necessary, unscrew all 4 screws and
carefully lift the lamp assembly straight out (Figure 4-3). Dispose of as per
instructions in Step 12.
Figure 4-3. Lamp Assembly Removal/Replacement
Your new lamp module has been precisely mounted on its own bracket. Do not
alter this assembly.
Carefully lower the new lamp assembly over the 2 alignment pins in the
projector (Figure 4-3). Make sure that the lamp is facing in the right direction—
the lens faces towards the center of the projector—and take care not to touch or
MAINTENANCE
Figure 4-2. Open the Projector
DLV 1280 User's Manual
4-5