Christie HAL Series User Manual page 91

OPTIONAL INPUT MODULES
E-2
DLV 1280
User's Manual
◊
accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync,
or separate horizontal and vertical sync)
◊
BNC connectors for RGB signal inputs
◊
RCA connectors for left and right channel audio inputs

The RGB400 Buffered Amplifier Input Module may be installed in a Marquee
signal switcher or Marquee Case/Power Supply and used with DLV 1280.
Connect three-, four-, or five-wire RGB video signals of up to 400 MHz
bandwidth, signals typically produced by high-resolution computers or
workstations. The buffering capability of the module enables the incoming signal
to be sent to a remote destination. Inputs are 75
◊
accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync,
or separate horizontal and vertical sync)
◊
BNC connectors for RGB signal inputs
◊
Buffered signals to a remote destination
◊
RCA connectors for left and right channel audio inputs

The RGB400 Active Loop Through Input Module may be installed in a Marquee
signal switcher or Marquee Case/Power Supply and used with DLV 1280. The
buffering capability of the RGB400 ALT, in combination with its pair of
input/output connectors, permit the original source signal to be sent intact to
multiple remote destinations. For example, you may want to display your data on
both a projector and a monitor, or perhaps two projectors. Inputs are 75
terminated.
◊
accepts 3, 4, or 5 wire RGB video (sync-on-green, composite sync,
or separate horizontal and vertical sync)
◊
BNC connectors for RGB signal inputs and outputs
◊
RCA connectors for left and right channel audio inputs
◊
buffered, active loop-through video outputs
5
terminated.
5