Restore Configuration; Restore Using Ftp; Table 111 General Commands For Gui-Based Tftp Clients - ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual

P-660H/HW/W-T Series User' Guide

Table 111 General Commands for GUI-based TFTP Clients

COMMAND DESCRIPTION
Host
Send/Fetch
Local File
Remote File This is the filename on the Prestige. The filename for the firmware is "ras" and for the
Binary
Abort
Refer to Section 33.2.5 on page 309
over WAN.

33.3 Restore Configuration

This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your Prestige
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
Note: Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE YOUR Prestige.

33.3.1 Restore Using FTP

For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter.
311
Enter the IP address of the Prestige. 192.168.1.1 is the Prestige's default IP address
when shipped.
Use "Send" to upload the file to the Prestige and "Fetch" to back up the file on your
computer.
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
configuration file, is "rom-0".
Transfer the file in binary mode.
Stop transfer of the file.
to read about configurations that disallow TFTP and FTP
Chapter 33 Firmware and Configuration File Maintenance