Packet Filtering Vs Firewall; Packet Filtering; When To Use Filtering; Firewall - ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual

Adsl 2+ gateway
Hide thumbs Also See for ADSL 2+ Gateway P-660HW-T1:
Table of Contents

Advertisement

P-660H/HW/W-T Series User' Guide
• Always shred confidential information, particularly about your computer, before
throwing it away. Some hackers dig through the trash of companies or individuals for
information that might help them in an attack.

10.7 Packet Filtering Vs Firewall

Below are some comparisons between the Prestige's filtering and firewall functions.

10.7.1 Packet Filtering:

• The router filters packets as they pass through the router's interface according to the filter
rules you designed.
• Packet filtering is a powerful tool, yet can be complex to configure and maintain,
especially if you need a chain of rules to filter a service.
• Packet filtering only checks the header portion of an IP packet.

10.7.1.1 When To Use Filtering

• To block/allow LAN packets by their MAC addresses.
• To block/allow special IP packets which are neither TCP nor UDP, nor ICMP packets.
• To block/allow both inbound (WAN to LAN) and outbound (LAN to WAN) traffic
between the specific inside host/network "A" and outside host/network "B". If the filter
blocks the traffic from A to B, it also blocks the traffic from B to A. Filters can not
distinguish traffic originating from an inside host or an outside host by IP address.
• To block/allow IP trace route.

10.7.2 Firewall

• The firewall inspects packet contents as well as their source and destination addresses.
Firewalls of this type employ an inspection module, applicable to all protocols, that
understands data in the packet is intended for other layers, from the network layer (IP
headers) up to the application layer.
• The firewall performs stateful inspection. It takes into account the state of connections it
handles so that, for example, a legitimate incoming packet can be matched with the
outbound request for that packet and allowed in. Conversely, an incoming packet
masquerading as a response to a nonexistent outbound request can be blocked.
• The firewall uses session filtering, i.e., smart rules, that enhance the filtering process and
control the network session rather than control individual packets in a session.
• The firewall provides e-mail service to notify you of routine reports and when alerts
occur.

10.7.2.1 When To Use The Firewall

• To prevent DoS attacks and prevent hackers cracking your network.
129
Chapter 10 Firewalls

Advertisement

Table of Contents
loading

Table of Contents