Route Ip Setup; Figure 121 Menu 3.2.1 Ip Alias Setup; Table 82 Menu 3.2.1 Ip Alias Setup - ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual

Figure 121 Menu 3.2.1 IP Alias Setup

Follow the instructions in the following table to configure IP Alias parameters.

Table 82 Menu 3.2.1 IP Alias Setup

FIELD
IP Alias
IP Address
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on the IP address
RIP Direction
Version
Incoming
Protocol Filters
Outgoing
Protocol Filters
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:

23.5 Route IP Setup

The first step is to enable the IP routing in Menu 1 — General Setup.
To edit menu 1, type 1 in the main menu and press [ENTER]. Set the Route IP field to Yes
by pressing [SPACE BAR].
Chapter 23 Internet Access
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
Choose Yes to configure the LAN network for the Prestige.
Enter the IP address of your Prestige in dotted decimal notation
that you assign. Unless you are implementing subnetting, use the subnet mask
computed by the Prestige
SPACE BAR
Press [ ] to select the RIP direction. Choices are None, Both, In Only
or Out Only.
SPACE BAR]
Press [ to select the RIP version. Choices are RIP-1, RIP-2B or RIP-
2M.
Enter the filter set(s) you wish to apply to the incoming traffic between this node and
the Prestige.
Enter the filter set(s) you wish to apply to the outgoing traffic between this node and
the Prestige.
" to save your configuration, or press [ESC] at any time to cancel.
P-660H/HW/W-T Series User' Guide
Press ENTER to Confirm
232