Table 83 Menu 4 Internet Access Setup - ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual

.
Menu 4 Internet Access Setup
Table 83
FIELD
ISP's Name
Encapsulation
Multiplexing
VPI #
VCI #
ATM QoS Type
Peak Cell Rate
(PCR)
Sustain Cell Rate
(SCR)= 0
Maximum Burst
Size (MBS)= 0
My Login
My Password
ENET ENCAP
Gateway
Idle Timeout
IP Address
Assignment
IP Address
Network Address
Translation
Address Mapping
Set
When you have completed this menu, press [ENTER] at the prompt "
or ESC to Cancel:
If all your settings are correct your Prestige should connect automatically to the Internet. If the
connection fails, note the error message that you receive on the screen and take the appropriate
troubleshooting steps.
Chapter 23 Internet Access
DESCRIPTION
Enter the name of your Internet Service Provider (ISP). This information is for
identification purposes only.
SPACE BAR
Press [ ] to select the method of encapsulation used by your ISP.
Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.
SPACE BAR
Press [ ] to select the method of multiplexing used by your ISP.
Choices are VC-based or LLC-based.
Enter the Virtual Path Identifier (VPI) assigned to you.
Enter the Virtual Channel Identifier (VCI) assigned to you.
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify fixed
(always-on) bandwidth. Select UBR (Unspecified Bit Rate) for applications that are
non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty traffic
and bandwidth sharing with other applications.
This is the maximum rate at which the sender can send cells. Type the PCR.
Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source that can
be sent at the peak rate, and a parameter for burst-traffic. Type the SCR; it must
be less than the PCR.
Refers to the maximum number of cells that can be sent at the peak rate. Type the
MBS. The MBS must be less than 65535.
Configure the My Login and My Password fields for PPPoA and PPPoE
encapsulation only. Enter the login name that your ISP gives you. If you are using
PPPoE encapsulation, then this field must be of the form user@domain where
domain identifies your PPPoE service name.
Enter the password associated with the login name above.
Enter the gateway IP address supplied by your ISP when you are using ENET
ENCAP encapsulation.
This value specifies the number of idle seconds that elapse before the Prestige
automatically disconnects the PPPoE session.
SPACE BAR
Press [ ] to select Static or Dynamic address assignment.
Enter the IP address supplied by your ISP if applicable.
SPACE BAR
Press [ ] to select None, SUA Only or Full Feature. Please see the
NAT chapter for more details on the SUA (Single User Account) feature.
Type the numbers of mapping sets (1-8) to use with NAT.
" to save your configuration, or press [ESC] at any time to cancel.
P-660H/HW/W-T Series User' Guide
Press ENTER to Confirm
234