ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual page 390

Adsl 2+ gateway
Hide thumbs Also See for ADSL 2+ Gateway P-660HW-T1:
Table of Contents

Advertisement

Table 138 Firewall Commands (continued)
FUNCTION
Sets
Appendix G
COMMAND
config edit firewall attack
minute-low <0-255>
config edit firewall attack
max-incomplete-high <0-255>
config edit firewall attack
max-incomplete-low <0-255>
config edit firewall attack
tcp-max-incomplete <0-255>
config edit firewall set <set
#> name <desired name>
Config edit firewall set <set
#> default-permit <forward |
block>
Config edit firewall set <set
#> icmp-timeout <seconds>
Config edit firewall set <set
#> udp-idle-timeout <seconds>
Config edit firewall set <set
#> connection-timeout
<seconds>
Config edit firewall set <set
#> fin-wait-timeout <seconds>
Config edit firewall set <set
#> tcp-idle-timeout <seconds>
P-660H/HW/W-T Series User' Guide
DESCRIPTION
This command sets the threshold of half-open
sessions where the Prestige stops deleting
half-opened sessions.
This command sets the threshold of half-open
sessions where the Prestige starts deleting old
half-opened sessions until it gets them down
to the max incomplete low.
This command sets the threshold where the
Prestige stops deleting half-opened sessions.
This command sets the threshold of half-open
TCP sessions with the same destination
where the Prestige starts dropping half-open
sessions to that destination.
This command sets a name to identify a
specified set.
This command sets whether a packet is
dropped or allowed through, when it does not
meet a rule within the set.
This command sets the time period to allow an
ICMP session to wait for the ICMP response.
This command sets how long a UDP
connection is allowed to remain inactive
before the Prestige considers the connection
closed.
This command sets how long Prestige waits
for a TCP session to be established before
dropping the session.
This command sets how long the Prestige
leaves a TCP session open after the firewall
detects a FIN-exchange (indicating the end of
the TCP session).
This command sets how long Prestige lets an
inactive TCP connection remain open before
considering it closed.
390

Advertisement

Table of Contents
loading

Table of Contents