ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual page 412

Table 152 IKE Logs (continued)
LOG MESSAGE
XAUTH fail! Username:
<Username>
Rule[%d] Phase 1 negotiation
mode mismatch
Rule [%d] Phase 1 encryption
algorithm mismatch
Rule [%d] Phase 1
authentication algorithm
mismatch
Rule [%d] Phase 1
authentication method
mismatch
Rule [%d] Phase 1 key group
mismatch
Rule [%d] Phase 2 protocol
mismatch
Rule [%d] Phase 2 encryption
algorithm mismatch
Rule [%d] Phase 2
authentication algorithm
mismatch
Rule [%d] Phase 2
encapsulation mismatch
Rule [%d]> Phase 2 pfs
mismatch
Rule [%d] Phase 1 ID mismatch The listed rule's IKE phase 1 ID did not match between the
Rule [%d] Phase 1 hash
mismatch
Rule [%d] Phase 1 preshared
key mismatch
Rule [%d] Tunnel built
successfully
Rule [%d] Peer's public key
not found
Rule [%d] Verify peer's
signature failed
Rule [%d] Sending IKE request IKE sent an IKE request for the listed rule.
Rule [%d] Receiving IKE
request
Swap rule to rule [%d]
Rule [%d] Phase 1 key length
mismatch
Rule [%d] phase 1 mismatch
Appendix K
P-660H/HW/W-T Series User' Guide
DESCRIPTION
The router was not able to use extended authentication to
authenticate the listed username.
The listed rule's IKE phase 1 negotiation mode did not match
between the router and the peer.
The listed rule's IKE phase 1 encryption algorithm did not
match between the router and the peer.
The listed rule's IKE phase 1 authentication algorithm did not
match between the router and the peer.
The listed rule's IKE phase 1 authentication method did not
match between the router and the peer.
The listed rule's IKE phase 1 key group did not match
between the router and the peer.
The listed rule's IKE phase 2 protocol did not match between
the router and the peer.
The listed rule's IKE phase 2 encryption algorithm did not
match between the router and the peer.
The listed rule's IKE phase 2 authentication algorithm did not
match between the router and the peer.
The listed rule's IKE phase 2 encapsulation did not match
between the router and the peer.
The listed rule's IKE phase 2 perfect forward secret (pfs)
setting did not match between the router and the peer.
router and the peer.
The listed rule's IKE phase 1 hash did not match between the
router and the peer.
The listed rule's IKE phase 1 pre-shared key did not match
between the router and the peer.
The listed rule's IPSec tunnel has been built successfully.
The listed rule's IKE phase 1 peer's public key was not found.
The listed rule's IKE phase 1verification of the peer's
signature failed.
IKE received an IKE request for the listed rule.
The router changed to using the listed rule.
The listed rule's IKE phase 1 key length (with the AES
encryption algorithm) did not match between the router and
the peer.
The listed rule's IKE phase 1 did not match between the router
and the peer.
412