Figure 138 Menu 11.1 Remote Node Profile; Figure 139 Menu 11.3 Remote Node Network Layer Options; Table 88 Remote Node Network Layer Options: Bridge Fields - ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual

P-660H/HW/W-T Series User' Guide

Figure 138 Menu 11.1 Remote Node Profile

Rem Node Name= ?
Active= Yes
Encapsulation= ENET ENCAP
Multiplexing= VC-based
Service Name= N/A
Incoming:
Rem Login= N/A
Rem Password= N/A
Outgoing:
My Login= N/A
My Password= N/A
Authen= N/A
3 Move the cursor to the Edit IP/Bridge field, then press [SPACE BAR] to set the value to
Yes and press [ENTER] to edit Menu 11.3 – Remote Node Network Layer Options.

Figure 139 Menu 11.3 Remote Node Network Layer Options

IP Options:
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set=2
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
The following table describes the fields in this menu.

Table 88 Remote Node Network Layer Options: Bridge Fields

FIELD
Bridge (menu 11.1)
Edit IP/Bridge (menu 11.1) Press [SPACE BAR] to select Yes and press [ENTER] to display menu
Ethernet Addr Timeout
(min.) (menu 11.3)
251
Menu 11.1 - Remote Node Profile
Press ENTER to Confirm or ESC to Cancel:
Menu 11.3 - Remote Node Network Layer Options
Press ENTER to Confirm or ESC to Cancel:
DESCRIPTION
Make sure this field is set to Yes.
11.3.
Type the time (in minutes) for the Prestige to retain the Ethernet Address
information in its internal tables while the line is down. If this information is
retained, your Prestige will not have to recompile the tables when the line
comes back up.
Route= IP
Bridge= Yes
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= N/A
Telco Option:
Allocated Budget(min)= N/A
Period(hr)= N/A
Schedule Sets= N/A
Nailed-Up Connection= N/A
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= N/A
Bridge Options:
Ethernet Addr Timeout (min)= 0
Chapter 26 Bridging Setup