ZyXEL Communications ADSL 2+ Gateway P-660HW-T1 User Manual page 391

Adsl 2+ gateway
Hide thumbs Also See for ADSL 2+ Gateway P-660HW-T1:
Table of Contents

Advertisement

P-660H/HW/W-T Series User' Guide
Table 138 Firewall Commands (continued)
FUNCTION
Rules
391
COMMAND
Config edit firewall set <set
#> log <yes | no>
Config edit firewall set <set
#> rule <rule #> permit
<forward | block>
Config edit firewall set <set
#> rule <rule #> active <yes |
no>
Config edit firewall set <set
#> rule <rule #> protocol
<integer protocol value >
Config edit firewall set <set
#> rule <rule #> log <none |
match | not-match | both>
Config edit firewall set <set
#> rule <rule #> alert <yes |
no>
config edit firewall set <set
#> rule <rule #> srcaddr-
single <ip address>
config edit firewall set <set
#> rule <rule #> srcaddr-
subnet <ip address> <subnet
mask>
config edit firewall set <set
#> rule <rule #> srcaddr-range
<start ip address> <end ip
address>
config edit firewall set <set
#> rule <rule #> destaddr-
single <ip address>
config edit firewall set <set
#> rule <rule #> destaddr-
subnet <ip address> <subnet
mask>
DESCRIPTION
This command sets whether or not the
Prestige creates logs for packets that match
the firewall's default rule set.
This command sets whether packets that
match this rule are dropped or allowed
through.
This command sets whether a rule is enabled
or not.
This command sets the protocol specification
number made in this rule for ICMP.
This command sets the Prestige to log traffic
that matches the rule, doesn't match, both or
neither.
This command sets whether or not the
Prestige sends an alert e-mail when a DOS
attack or a violation of a particular rule occurs.
This command sets the rule to have the
Prestige check for traffic with this individual
source address.
This command sets a rule to have the Prestige
check for traffic from a particular subnet
(defined by IP address and subnet mask).
This command sets a rule to have the Prestige
check for traffic from this range of addresses.
This command sets the rule to have the
Prestige check for traffic with this individual
destination address.
This command sets a rule to have the Prestige
check for traffic with a particular subnet
destination (defined by IP address and subnet
mask).
Appendix G

Advertisement

Table of Contents
loading

Table of Contents