Ametek Thermox 2000 ATEX Series User Manual page 88

1.
1.
2.
4-20 | Thermox Series 2000 WDG-HPII / HPIIC - ATEX
System Password
System passwords are created using the Setup key. Please see the
"Setup Key" section for information on defining or disabling a
system password.
NOTE
If a system password is enabled, you will be required to correctly enter
this password before accessing Analog Range key functions.
When you select the Analog Range key, you will be prompted to enter
your system password:
Enter password
Enter the four digit system password. To protect the identification of
the password, the numbers you enter will not be displayed.
You will then be able to access Analog Range key functions.
Analog Output Port
Before you can define any Analog Range key functions, you must first
choose whether they will apply to analog output ports 1 or 2 on the rear
of the control unit. In addition, if you have the combustibles option, you
can also use analog output ports 3 and 4. Analog output port 1 is labeled
IOUT 1; analog output port 2 is labeled IOUT 2. In addition, if you have
the combustibles card option, analog output port 3 is labeled IOUT 3 and
analog output port 4 is labeled IOUT 4. Analog output ports 3 and 4 can
only be used for combustibles.
Do the following to select an analog output port:
Select the Analog Range key.
Select Current Output #1 or Current Output # 2. If you have the
combustibles option, you can also select Current Output # 3 or
Current Output # 4.
You can then select any of the menu options described in the remainder
of this chapter, and they will apply to your selected analog output port.