Ametek Thermox 2000 ATEX Series User Manual page 74

Display
Passwords
Process Pressure
System Tests
System Serial #
Primary Calibration
Sensor Configuration
Communication
Combustibles
Figure 4-3.
Overview of setup key
functions.
4-6 | Thermox Series 2000 WDG-HPII / HPIIC - ATEX
Perform a primary calibration on the sensor (primary calibration).
This is not a typical calibration. A primary calibration is intended to
extend the life of your sensor. Do not perform this type of calibration
unless specifically instructed to do so.
Select the type of sensor you are using (Sensor Configuration).
Define Series 2000 communication parameters (Communication).
Select combustible detector options (Combustibles). This only applies
if you purchased a combustibles detector(s).
SETUP KEY
MENU OPTIONS`
FUNCTION/OPTIONS
Select info for Display line 1.
Select info for Display line 2.
Select info for Display line 3.
Create a system password.
Select positive or negative process
pressure. Enter process pressure
value.
Perform internal diagnostics on Series
2000.
View Serial # for Series 2000.
View Mfg. # for Series 2000.
Performa an automatic, remote, or
manual primary calibration.
Select sensor type.
Define communication parameters.
Define combustibles scale (% or PPM).
Define combustible detector type.