Ametek Thermox 2000 ATEX Series User Manual page 123

5. Enter the time you want the first calibration or verification to begin,
then press the Enter key. The system uses military time, so to enter
4:00 p.m., you would type 16:00. If, for example, you set the cycle
frequency at 8 hours, and specify the first calibration to take place at
4:00 p.m., the next automatic calibration or verification will take place
at midnight.
Set Cal Timers - Set Time and Date
This menu option allows you to set the date or time for the internal
control unit clock.
Make sure the current time and date are correct before setting any
auto cal/auto verify parameters.
NOTE
1. Select Set Time & Date from the Set Cal Timers menu.
You are prompted to enter the new time:
The time is: YY:XX
Enter new time: HR: Mn
2. Enter the new time, then press the Enter key. As you type the new
time, it overwrites the Hr: Mn text. The Series 2000 control unit uses
military time so 16:00 equals 4:00 p.m., and 04:00 equals 4:00 a.m. If
the current time is correct, press the Enter key without changing the
value.
You are then prompted to enter the correct date:
The date is: YY/XX/ZZ
Enter date: Mo/Da/Yr
3. As you type the new date, it overwrites the mo/da/yr text on the
display. Enter the month, the day, the year, then press the Enter key.
If the current date is correct, press the Enter key without changing
the value.
Calibration | 5-23