Ametek Thermox 2000 ATEX Series User Manual page 105

Calibrate Key Menu Options
Initiate Cal/Initiate Verify
Cal/Verify Data
Cal Gas Values
Inject Cal Gas
Set Cal Timers
(applies only for auto cal
operations with RCU,
except for setting time
and date)
Set K Factor
Sensitivity
Figure 5-2.
Overview of calibrate
key functions.
Functions/Options
Start an automatic, remote, or manual
calibration or verify.
View latest calibration and verify data.
- Cal data
- Verify data
Enter calibration gas values.
Set pressure and flow of RCU gases without
performing a calibration.
- Set control unit time/date.
- Enable or disable auto cal cycles.
- Set cal gas times for auto cal/verify
operations.
- Define recovery durations after a cal/verify.
Enter Value
View the Sensitivity (Slope) determined during
calibration for the combustibles detector
in mV/1000 ppm
Calibration | 5-5