Ametek Thermox 2000 ATEX Series User Manual page 131

Primary Calibration
This message appears when the system is performing a primary Calibra-
tion (see the Setup key for further information on primary calibration).
The message continues to be displayed during the recovery period after
the primary calibration.
System Calibrating
This message indicates that a system calibration is in progress. It will ap-
pear during the entire automatic calibration cycle or during the recovery
period of a remote or manual calibration.
System Verifying Cal
This message indicates that a system verification is in progress. It will ap-
pear during the entire automatic verification cycle or during the recovery
period for a remote or manual verification.
Maintenance and Troubleshooting | 6-3