Ametek Thermox 2000 ATEX Series User Manual page 33

SENSOR BOLTED TO MOUNTING PLATE AFTER
PLATE IS WELDED TO NIPPLE BY CUSTOMER
EXHAUST TUBE
GASKET (BY AMETEK)
AMETEK SUPPLIED MOUNTING PLATE
WITH 2 7/8"OD X 9" LONG NIPPLE
(7.30cm X 22.86cm)
PROCESS WALL
FILTER
SAMPLING PROBE
(INSIDE EXHAUST TUBE)
LENGTH MINIMUM
NECESSITATED BY
INSULATING SLEEVE
PIPE NIPPLE
INSTALLATION
(SUPPLIED BY CUSTOMER)
REQUIRES 1" (2.54cm) MIN
SIDE VIEW
INSULATION AROUND EXPOSED
PORTION OF NIPPLE
SINGLE STUD
AT "12 O'CLOCK"
POSITION
FRONT VIEW
PROPER ORIENTATION FOR
MOUNTING PLATE TO FLANGE
Figure 3-4.
Customer-supplied pipe
nipple sensor mounting.
|
Installation 3-9