Intrinsyc LANTRONIX Open-Q 820 User Manual page 15

3.7.1 µSOM Mechanical Properties
Area
Interface
Thermal
Shielding
3.7.2 µSOM Block Diagram
The Open-Q 820 / 820Pro µSOM measuring 25mm x 50mm is where all the processing occurs. It is connected
to the carrier via three 100 pin Hirose DF40 connectors. The purpose of these connectors is to bring out essential
signals such that other peripherals can be connected to the platform.
3.8 Anti-Static Handling Procedures
Open-Q™ 820 / 820Pro µSOM Dev Kit User Guide
50 mm
Figure 3 Open-Q 820 / 820Pro µSOM
Open-Q 820 µSOM Development Kit
25 mm
12.5 cm (25 mm x 50 mm)
2
3 x 100-pins Hirose DF40 connectors (B2B
Connector).
A top side heat sink is installed by default.
A top side shield can for the GPS front end
is installed by default.
15