Remove and Install Front Vertical
Caster Bearings
Removal
1. Park and prepare machine for service. See "Prepare
Equipment for Service" on page 1-13.
2. Raise platform and support with appropriate device.
Figure 5-29
3. Remove cap (1).
Figure 5-30
4. Remove fastener (2).
Z400 Series
1
HUS1052
2
HUS1121
5-11
1
3
5
5
1) Cap
2) Fastener
3) Cap Spring
4) Spring Nested Wave
Figure 5-31
5. Remove components as shown.
6. Clean and inspect components. Repair or replace as
necessary.
7. Repeat steps 3–6 for other caster bearing.
Installation
Installation is done in reverse order of removal.
Tighten fastener (2) to specification.
Specification
Fastener (2) Torque
• Grease caster bearing. See "Lubricate Caster
Bearings" on page 3-5.
REPAIR
2
4
6
7
HUS1122
5) Bearing (2 used)
6) Zerk
7) Seal
50 ft-lb (68 N•m)