MAINTENANCE
Check and Fill Transmission
Fluid
NOTICE
The transmission has two closed-loop drive
systems. One drive system is for the left wheel
and the other drive system is for the right
wheel.
1. Park and prepare machine for service. See "Prepare
Equipment for Service" on page 1-13.
2. Raise seat.
2
Figure 3-8
3. Remove hydraulic oil dipstick (1 or 2) and check
hydraulic oil.
4. Add hydraulic oil if needed.
5. Purge the transmission. See "Purging Procedure" on
page 3-7.
Change Transmission Oil and
Filters
Change the transmission oil when the system is
warm. Refer to the operator manual for the
correct replacement oil and filter change
recommendations to avoid voiding the
transmission warranty.
The transmission has two closed-loop drive
systems. One drive system is for the left wheel
and the other drive system is for the right
wheel.
1. Park and prepare machine for service. See "Prepare
Equipment for Service" on page 1-13.
2. Raise seat.
1
HUS1040
3. Remove transmission oil dipstick (1 or 2).
4. Place appropriate container under transmission.
3-6
NOTICE
2
Figure 3-9
Z400 Series
1
HUS1040