REPAIR
Figure 5-19
3. Remove nut (2) from choke.
Figure 5-20
4. Remove fastener (3) and choke cable (4).
5. Inspect choke cable. Replace as necessary.
Installation
Installation is done in reverse order of removal.
• Adjust choke cable. See "Check and Adjust Choke
Cable" on page 4-5.
2
3
4
Remove and Install Fuel Tank
Removal
1. Park and prepare machine for service. See "Prepare
Equipment for Service" on page 1-13.
HUS1076
2. Remove fasteners (1) and set console panel (2)
aside.
B2
HUS1054
5
3. Install identification tags and disconnect float level
sensor (B2).
4. Install identification tags and disconnect fuel line (3)
and rollover valve hose (4). Close all openings using
caps and plugs.
5. Remove fasteners (5).
5-8
1
1
2
1
Figure 5-21
3
4
Figure 5-22
HUS1013
5
HUS1081
Z400 Series