Configuration Status Indicators - Lattice Semiconductor LatticeSC PCI Express x1 User Manual

Lattice Semiconductor
4. Press the SCAN button located in the toolbar. The LatticeSC device is automatically detected.
5. Double-click the device to open the device information dialog. In the device information dialog, click the
Browse button located under Data File . Locate the desired bitstream file (.bit). Click OK to both dialog boxes.
6. Click the green GO button. This will begin the download process into the device. Upon successful download,
the device will be operational.
Configuration Status Indicators
(see Appendix A, Figure 5)
These LEDs indicate the status of configuration to the FPGA.
• D2 (RED) illuminated: This indicates that the programming was aborted or reinitialized driving the INITN output
low.
Evaluation Board User's Guide
7
LatticeSC PCI Express x1