Printing The Setting Of The Plotter - GRAPHTEC CE6000 Series Service Manual

8.3

Printing the Setting of the Plotter

Condition setting list can be printed when you need to check the current setting of the plotter.
Operation
(1) Set a paper larger than A3 size.
(2) Set the pen tool to the tool carriage and select the condition where the pen tool is set.
(3) Press the PAUSE/MENU key at the following menu.
(4) The following menu is displayed, and then press the left arrow key (TEST).
(5) The following menu is displayed, and then press the F1 key (CONDITION LIST).
(6) Press the F1 key (CONDITION LIST) to display the menu below.
(7) Press the F1 key (DONE 1/2) or the F2 key (DONE 2/2).
Message to confirm tool position is displayed.
(8) Move the tool carriage to print start position by using the POSITION key.
(9) Press the ENTER key to start printing the condition list.
It will return to READY status when the printing is completed.
CE6000-UM-251-9370 8-4
8 SERVICE MODES