Adjusting The Y Limit Position (Ce6000-120Ap) - GRAPHTEC CE6000 Series Service Manual

7 ELECTRICAL ADJUSTMENTS
7.14

Adjusting the Y Limit Position (CE6000-120AP)

This adjustment will set the Y limit position for the CE6000-120AP.
If you replace the main board, use the following procedure to set the Y limit position.
This adjustment was added from the firmware version 1.50 of CE6000-120AP. Update the firmware first if
the firmware version is older than 1.50.
How to adjust the Y limit position
(1) Load an A4 size sheet of paper into the plotter.
(2) Turn on the power while pressing the FAST and ENTER keys.
(3) Select the Language and the Length Unit if the Language selection menu is displayed (See section
7.5.).
(4) Press the PAUSE/MENU key at the following menu.
(5) The following menu is displayed, and then press the right arrow key (ADJ).
(6) The following menu is displayed.
(7) Press the up arrow key until the following menu is displayed.
(8) Press the F4 key to display the menu shown below.
CE6000-UM-251-9370 7-35