Rear Media Sensor; Push Roller - GRAPHTEC CE6000 Series Service Manual

6.2.2 Rear Media Sensor

How to detach the rear media sensor
(1) Detach the rear guide (See section 6.1.6.) for the CE6000-40 and 60.
Detach the rear guide (See section 6.1.7.) for the CE6000-120.
(2) Remove the M3L12 binding head screw holding the rear media sensor.
(3) Disconnect the cable from the rear media sensor.
How to reinstall the rear media sensor
(1) Reattach the rear media sensor in the reverse order in which it was detached.
(2) Perform the RMS sensor and the paper sensor position adjustment when the media sensor is
replaced (See section 7.11.).

6.2.3 Push Roller

How to detach the push roller
(1) Detach the right side of the E-ring from the push roller shaft.
(2) Detach the push roller shaft from the push roller arm from the left side.
(3) Detach the push roller.
How to reinstall the push roller
(1) Reattach the push roller in the reverse order in which it was detached.
CE6000-UM-251-9370
Push roller arm
Push roller
6 DISASSEMBLY AND REASSEMBLY
Rear media sensor
M3L12 binding head screw
Push roller shaft
E-ring
6-8