Dräger Caleo Instructions For Use Manual page 123

After cleaning mode* has completed or if humidity control
is not provided:
Switch off incubator. Disconnect from line power and
disconnect the medical gas supply.
WARNING !
Always disconnect all supplies before disassembly.
Remove any auxiliary equipment installed (for care
instructions see the particular Instructions for Use of the
respective equipment).
WARNING !
Risk of burns upon contact with the heater.
Allow Caleo to cool down before further disassembly.
Removing the double wall
1
Pull the pin up as far as it will go.
The red section of the pin must be visible.
2
Hold the double wall with both hands and lift it off.
Place the double wall on a soft, non-scratch surface.
Remove the contour seal from the double wall.
3
Force the sleeve open
and at the same time
4
pull out the pin.
1
2
3
4
Care
Disassembly
2
123