Dräger Caleo Instructions For Use Manual page 120

Care
Testing of procedures and agents
Disinfect and clean accessories such as the aspiration unit in
accordance with their specific Instructions for Use.
Water heater
The water heater does not have any components that must be
dismantled for the preparation.
Execute the Cleaning Mode after each change of patient.
While preparing the interior of the incubator, ensure that no
liquids such as detergents penetrate into the water heater.
Skin temperature sensors (MX11000/MX11001)
Skin temperature sensors are disposable products and should
not be reused, reprocessed or sterilized.
Any reuse, reprocessing or sterilising can lead to the failure
of the medical device.
Hood, flaps and other plastic parts
To avoid impairment of function and long-term damages,
use only suitable detergents or disinfectants and handle parts
carefully.
Plastic parts, especially transparent flaps and hoods made of
polycarbonate (PC), are sensitive to mechanical and chemical
exposure.
When cleaning and disinfecting, do not exceed the reaction
time specified by the manufacturer. Fully remove cleaning
agent and disinfectant residue after the reaction time, even
from the clearances.
Softbed
Clean and wipe-disinfect the softbed MX17012 as required,
and after each patient change. In case of heavy soiling, the
o
cover can be washed in the washing machine at 95 C. A drier
o
is suitable up to 95 C.
In exceptional cases, the mattress core can get stained. The
mattress core (foam) can then be washed in the washing
o
machine with mild detergent at 30 C.
Sterilization
Sterilization frees living microorganisms from semicritical me-
dical products and removes residual water from the interior
spaces of its items.
Only sterilze cleaned and disinfected items.
Use a vacuum steam sterilizer (in accordance with
DIN EN 285), preferably with fractional vacuum.
Do not use gas sterilization with ethylene oxide (EO).
120