Keysight Technologies N778 C Series Programming Manual page 80

5 Polarization Commands
Command: :PCONtroller:SEQuence:SMODe?
Syntax: :PCONtroller:SEQuence:SMODe?
Description: Returns the current configured Sequence Mode
0 = Sequence will automatically start and restart when reaching the end.
1 = Sequence will automatically start and run only once.
2 = Sequence will start when a low/high-transition is detected on the BNC input.
When reachig the end of the sequence, it will be restarted.
3 = Same as above, except that the sequence will not be repeated.
4 to 6 = sequence stepped mode - single extern trigger
Parameters: None
Response: Integer value
Example: :PCONtroller:SEQuence:SMODe? +0
Affects N7785C / N7786C / N7788C
Command: :PCONtroller:SEQuence:DCOMpensation
Syntax: :PCONtroller:SEQuence:DCOMpensation<wsp><value>
Description: Set the polarization controller drift-compensation.
0 = drift-compensation is OFF (dynamic correction is inactive)
1 = drift-compensation is ON (dynamic correction is active) (DEFAULT)
Parameters: Boolean integer value
Response: None
Example: :PCONtroller:SEQuence:DCOMpensation 1
Affects N7785C / N7786C / N7788C
Command: :PCONtroller:SEQuence:DCOMpensation?
Syntax: :PCONtroller:SEQuence:DCOMpensation?
Description: Get the polarization controller drift-compensation.
0 = drift-compensation is OFF (dynamic correction is inactive)
1 = drift-compensation is ON (dynamic correction is active)
Parameters: None
80 Keysight N778xC Series Polarization Instruments Programming Guide