Keysight Technologies N778 C Series Programming Manual page 79

Response: None
Example: :PCONtroller:SEQuence:RRATe 50.2
Affects N7785C / N7786C / N7788C
Command: :PCONtroller:SEQuence:RRATe?
Syntax: :PCONtroller:SEQuence:RRATe?
Description: Get the polarization controller repetition rate for each datapoint in kHz
Parameters: None
Response: Double value
Example: :PCONtroller:SEQuence:RRATe? +5.02000000E+01
Affects N7785C / N7786C / N7788C
Command: :PCONtroller:SEQuence:SMODe
Syntax: :PCONtroller:SEQuence:SMODe<wsp><mode>
Description: Sets the sequence mode.
A sequence consist of the number of datapoints multiplied by the repetition (repetition=0 means endless)
0 = Sequence will automatically start and restart when reaching the end.
1 = Sequence will automatically start and run only once (like repetition=1).
2 = Sequence will start when a low/high-transition is detected on the BNC input.
When reaching the end of the sequence, it will be restarted.
3 = Same as above, except that the sequence will not be repeated.
4 to 6 = sequence stepped mode - single extern trigger config waveform, define repetitions / repetition rate , set SyncMode,
start/arm scrambler (:PCON:STARt)
Parameters: Integer value
Response: None
Example: :PCONtroller:SEQuence:SMODe 0
Affects N7785C / N7786C / N7788C
Keysight N778xC Series Polarization Instruments Programming Guide
Polarization Commands 5
79