Keysight Technologies N778 C Series Programming Manual page 71

Command: :POLarimeter:SWEep:SRATe?
Syntax: :POLarimeter:SWEep:SRATe?[<wsp>MIN|MAX|DEF]
Description: This command gets the sampling rate and averaging time
Parameters: None: to get current sampling rate and averaging time
MIN: minimum sampling rate
MAX: maximum sampling rate
DEF: default sampling rate
Response: No parameter:
MIN|MAX|DEF parameter:
Example: :pol:swe:srat? → +1e+06,+1e-06
Affects N7781C / N7786C / N7788C
Command: :POLarimeter:SWEep:LPRange?
Syntax: :POLarimeter:SWEep:LPRange?
Description: Returns how well the ADC range was used for the last peak power. If this value is below 0.5, the measurement sweep should
be repeated with a higher amplifier gain setting. If the Value is > 1.0 then there is an increasing Risk of Overflow.
Select a lower amplifier setting in this case.
NOTE: use only gain between 0 and 7 for Stabilizer Mode because 8 and 9 have a
small Bandwith
Parameters: None
Response: Float
Example: :pol:swe:lpr? → +0.50000000E+00
Affects N7781C / N7786C / N7788C
Command: :POLarimeter:SWEep:STEP
Syntax: :POLarimeter:SWEep:STEP<wsp><value>[m|nm|pm]
Description: Sets the sweep step in m
Keysight N778xC Series Polarization Instruments Programming Guide
sampling rate in float
averaging time in float
sampling rate in float
Polarization Commands 5
71