System:help:errors; System:time - Keysight Technologies N778 C Series Programming Manual

Command:

:SYSTem:HELP:ERRors?

Syntax: :SYSTem:HELP:ERRors?
Description: Return an overview about all Errorcodes and a short description.
Parameters: none
Response: String list of error codes
Example: :syst:help:err? -> +0,"No error",-100,"Command error",- 101,"Invalid character",-102,"Syntax error",-103,
"Invalid separator",-104,"Data type error",-105,"GET not allowed",-108,"Parameter not allowed",...
Command: :SYSTem:PRESet
Syntax: :SYSTem:PRESet
Description: Sets the instrument to the standard settings. This command has the same function as the Preset hardkey.
Pressing the "LAN Reset" Button for a short time has the same effect.
Long pressing of the "LAN Reset" Button resets the LAN parameter.
The following are not affected by this command:
the interface address,
the output and error queues,
the Service Request Enable register (SRE),
the Status Byte (STB),
the Standard Event Status Enable Mask (SESEM), and
the Standard Event Status Register (SESR).
Parameters: none
Response: none
Example: :SYST:PRES
Command:

:SYSTem:TIME

Syntax: :SYSTem:TIME<wsp><hour>,<minute>,<second>
Description: Sets the instrument's internal time.
Parameters: 24-hour time format: hours (0-23), minutes (0-59), seconds (0-59).
Response: none
Example: :syst:time 20,15,30
Keysight N778xC Series Polarization Instruments Programming Guide
Instrument Setup and Status 3
35