Keysight Technologies N778 C Series Programming Manual page 100

6 Error Codes
100
Error
Number String
-330 "Self-test failed"
Description:
You have started the self test, but the module has detected an error while executing it
-340 "Calibration failed"
-350 "Queue overflow"
[A specific code entered into the queue in lieu of the code that caused the error. This code
indicates that there is no room in the queue and an error occurred but was not recorded.]
-360 "Communication error"
-361 "Parity error in program message"
-362 "Framing error in program message"
-363 "Input buffer overrun"
-365 "Time out error"
-368 "LambdaStop<=LambdaStart"
-369 "sweepTime < min"
-370 "sweepTime > max"
-371 "triggerFreq > max"
-372 "step < min"
-373 "triggerNum > max"
-374 "LambdaLogging = On AND Modulation = On AND ModulationSource! = CoherenceControl"
-375 "LambdaLogging = On AND TriggerOut! = StepFinished"
-376 "Lambda logging in stepped mode"
-377 "step not multiple of 0.1pm"
-378 "triggerFreq < min"
-400 "Query error"
[This is the generic query error for devices that cannot detect more specific errors. This code
indicates only that a Query Error as defined in IEEE 488.2, 11.5.1.1.7 and 6.3 has occurred.]
-410 "Query INTERRUPTED"
[Indicates that a condition causing an INTERRUPTED Query error occurred (see IEEE 488.2,
6.3.2.3); for example, a query followed by DAB or GET before a response was completely sent.]
Keysight N778xC Series Polarization Instruments Programming Guide