Keysight Technologies N778 C Series Programming Manual page 73

Command: :POLarimeter:SWEep:TRIGger:POST:SAMPles
Syntax: :POLarimeter:SWEep:TRIGger:POST:SAMPles
Description: Sets the number of post samples. That means samples after trigger event.
Numbers of pre samples and post samples have to be smaller than 1048576.
Parameters: Number of post samples
Example: :pol:swe:trig:post:samp 2000
Affects N7781C / N7786C / N7788C
Command: :POLarimeter:SWEep:TRIGger:POST:SAMPles?
Syntax: :POLarimeter:SWEep:TRIGger:POST:SAMPles?
Description: Returns the number of post samples
Parameters: None
Response: Number of post samples
Example: :pol:swe:trig:post:samp? → +2000
Affects N7781C / N7786C / N7788C
Command: :POLarimeter:SWEep:CONTinuous:SACCuracy
Syntax: :POLarimeter:SWEep:CONTinuous:SACCuracy
Description: Sets the SOP accuracy in rad used in the continuous sampling mode.
A value of 0 causes all samples to be stored.
Otherwise SOP changes smaller than SOP accuracy will not cause a sample to be stored.
Parameters: SOP accuracy in rad
Example: :pol:swe:cont:sacc 0.1
Affects N7781C / N7786C / N7788C
Keysight N778xC Series Polarization Instruments Programming Guide
Polarization Commands 5
73