System:communicate:ethernet:autoip:enable; System:communicate:ethernet:cancel; System:communicate:ethernet:dgateway - Keysight Technologies N778 C Series Programming Manual

Command:

:SYSTem:COMMunicate:ETHernet:AUTOip:ENABle

Syntax: :SYSTem:COMMunicate:ETHernet:AUTOip:ENABle
Description: Enable or disable whether IP addresses can be created automatically by the instrument. Automatic IP addressing is only
used if DHCP is enabled, but the instrument cannot find a DHCP server.
Parameters: Boolean (0 | 1 | off | on)
Response: None
Example: :SYST:COMM:ETH:AUTO:ENAB 1
Command:

:SYSTem:COMMunicate:ETHernet:CANCel

Syntax: :SYSTem:COMMunicate:ETHernet:CANCel
Description: Undo all changes to the network parameters that have been made since the last save, reboot or ":syst:comm:eth:restart"
command.
Parameters: None
Response: None
Example: :SYST:COMM:ETH:CANC
Command:

:SYSTem:COMMunicate:ETHernet:DGATeway

Syntax: :SYSTem:COMMunicate:ETHernet:DGATeway
Description: Set the default gateway.
Parameters: string (Up to four groups of up to 3 digits, groups separated by ".". Groups with leading zeros are interpreted as octal
numbers.)
Response: None
Example: :syst:comm:eth:dgat "192.168.101.11"
Command: :SYSTem:COMMunicate:ETHernet:DGATeway?
Syntax: :SYSTem:COMMunicate:ETHernet:DGATeway?
Description: Get the default gateway.
Keysight N778xC Series Polarization Instruments Programming Guide
Instrument Setup and Status 3
39