Resetting A Fault; The Loc/Rem Button - Honeywell HVAC400x Applications Manual

SELECTING MORE THAN ONE VALUE
Some parameters let you to select more than one value. Select a checkbox at each necessary value.
1. Find the parameter. There is a symbol on the display when
a checkbox selection is possible.
(LEGEND: A = The symbol of the checkbox selection.)
2. To move in the list of values, use the UP and DOWN arrow
buttons.
3. To add a value into your selection, select the box that is
next to it using the RIGHT arrow button.
3.2.2

Resetting a Fault

To reset a fault, you can use the Reset button or the parameter Reset Faults. See also
View.
3.2.3

The LOC/REM Button

You can use the LOC/REM button for three functions.
• To access the Control page.
• To easily change between the Local and Remote control places.
• To change the rotation direction (in Keypad mode, only)
The selection of the control place determines from where the HVAC drive takes the Start and Stop commands. All
the control places have a parameter for the selection of the frequency reference source. The Local control place is
always the keypad. The Remote control place is I/O or Fieldbus. You can see the current control place on the
status bar of the display.
HVAC400X – APPLICATION MANUAL
STOP
A
STOP
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
STOP
Sunday
Monday
Tuesday
Wednesday
Thursday
Friday
23
READY
Interval 1
ID:1466 M3.12.1.3
ON Time
00:00:00
OFF Time
00:00:00
Days
READY
Days
ID:
M3.12.1.3.1
READY
Days
ID:
M3.12.1.3.1
11.1 A Fault Comes into
EN2B-0417GE51 R0719
I/O
0
I/O
I/O