HVAC400X – APPLICATION MANUAL
10.8
Limit Supervisions
P3.8.1 SUPERVISION #1 ITEM SELECTION (ID 1431)
You can use this parameter to select the supervision value.
P3.8.2 SUPERVISION #1 MODE (ID 1432)
You can use this parameter to set the supervision mode.
When the 'Low limit' mode is selected, the output of the supervision function is active when the signal is below the
supervision limit.
When the 'High limit' mode is selected, the output of the supervision function is active when the signal is above the
supervision limit.
P3.8.3 SUPERVISION #1 LIMIT (ID 1433)
You can use this parameter to set the supervision limit for the selected item.
The unit shows automatically.
P3.8.4 SUPERVISION #1 LIMIT HYSTERESIS (ID 1434)
You can use this parameter to set the supervision limit hysteresis for the selected item.
The unit shows automatically.
P3.8.5 SUPERVISION #2 ITEM SELECTION (ID 1435)
You can use this parameter to select the supervision item.
The output of the supervision function can be selected to the relay output.
P3.8.6 SUPERVISION #2 MODE (ID 1436)
You can use this parameter to set the supervision mode.
When the 'Low limit' mode is selected, the output of the supervision function is active when the signal is below the
supervision limit.
When the 'High limit' mode is selected, the output of the supervision function is active when the signal is above the
supervision limit.
P3.8.7 SUPERVISION #2 LIMIT (ID 1437)
You can use this parameter to set the supervision limit for the selected item.
The unit shows automatically.
P3.8.8 SUPERVISION #2 LIMIT HYSTERESIS (ID 1438)
You can use this parameter to set the supervision limit hysteresis for the selected item.
The unit shows automatically.
125
EN2B-0417GE51 R0719