3.2.1
Editing the Values
On the graphical display, there are two different procedures to edit the value of an item. Usually, you can set only
one value for a parameter. Select from a list of text values or from a range of numerical values.
CHANGING THE TEXT VALUE OF A PARAMETER
1.
Find the parameter using the arrow buttons.
2.
To enter the Edit mode, press the OK button two times or
press the RIGHT arrow button.
3.
To set a new value, press the UP and DOWN arrow
buttons.
4.
To accept the change, press the OK button. To discard the
change, use the BACK/RESET button.
HVAC400X – APPLICATION MANUAL
STOP
Start / Stop Setup
Rem Control Place
KeypadStopButton
STOP
Edit
i
Help
Add to Favourites
STOP
21
READY
ID: 172
M3.2.1
I/O Control
Yes
Start Function
Ramping
READY
Rem Control Place
ID:
M3.2.1
READY
Rem Control Place
ID:
M3.2.1
FieldbusCTRL
I/O Control
EN2B-0417GE51 R0719
I/O
I/O
I/O