Drain Process; Soak Process - Renesas R8C Series User Manual

RSSHEUM0003 - 0101
Rev.1.00
At the first time inlet of the rinse-spin type, if water level failed to rise up 2 levels in 2 minutes,
the program will change to normal type rinse instead of rinse-spin type.
If user setting water level value is higher than the 4
washing program begin to run the next step process, and washing motor run with the
corresponding stream based on the rising water level, which will last till water reaching user
setting value.
During inlet running, if lid is open, platform will alarm and run the error processing program.

3.2.2 Drain process

In drain process, the drain triac switched on till water is drained off, after that, the platform will keep
draining for 60 seconds and then begins to run the next step process. The time set for drain process is
2 minutes, while this process exceeds 2 minutes, washing program will stop time counting; and if the
process finished in less than two minutes, the process running time still calculated as 2 minutes.
If there is even no water in the tube at the beginning of drain process, the platform still keep draining
for 10 seconds and then platform starts to run the next step process. If the tube has not been drained
off in 8 minutes, platform will alarm and start to run error processing program.

3.2.3 Soak process

Based on the available soak time setting, washing program separate washing motor cycle time as 3
types and 4 kinds of combinations as below. During soak running, if lid is open, platform will alarm
and run the error processing program.
Below are the 3 types of the motor cycles:
A: 2 minutes motor cycle + 3 minutes stop
B: 1 minutes motor cycle + 4 minutes stop
C: 1 minutes motor cycle + 9 minutes stop
Below are the 4 kinds of motor cycle combinations based on A, B and C motor cycle types:
a), 10 minutes group (A, B);
b), 20 minutes group (A, B, C);
c), 30 minutes group (A, B, C, C);
d), 40 minutes group (A, B, C, C, C);
Renesas System Solution (Beijing) Co., Ltd, Shanghai Branch
Unit 207 AZIA Center, No.1233 Lujiazui Ring Road, Pudong District, Shanghai, China
Tel: (86-21) 6888-0556 Fax: (86-21) 6888-0559
th
level, while water reach to the 3
Page 32
Zip: 200120
rd
level,