Renesas R8C Series User Manual page 26

RSSHEUM0003 - 0101
Rev.1.00
" The first time rinse water "
" The first & second time rinse water "
first & second & third time rinse water "
If only two times or less rinse time selected, the display value will pass over the items that include
the non-selected rinse time. For example, if only 2 times rinse selected, the display cycle is as below:
" The first time rinse water "
rinse water " (no display)
While user select save water function, the drain process will be paused in the end of a rinse process,
the buzzer buzzes 20 times (0.5s on 0.5s off) to indicate the save water is ongoing, and at the same
time, platform LCD will display how many save water time is left during current program setting.
After user press " Start / Stop " key, the drain valve is switched open and the washing program
resumes. If user does not press the " Start / Stop " key within 4 hours, washing program will start the
drain process and run the unfinished program.
For program left time calculation, if save water function selected, the time that the washer wait for
user to release save water function is not included in the running time.
2.2.3.7 Preset setting display
This is the menu page for user to set the preset time of the selected washing program. The default
displayed value is " 2 hours ", by pressing " + " or " - " key user can shift up and down the available
preset running time from " 2 hours " to " 24 hours "; there is no " 0 hour " and " 1 hour " option,
instead, after option " 24 hours " there is an no display items inserted before cycle to " 2 hours "
option.
If " OK " key pressed, the preset function is enabled and the preset is running after " Start / Stop "
key pressed; and the fourth level menu will display preset left time and other selected washing
program parameters. The preset program start time is calculated using preset time subtracting the
program longest running time and then adding 15 minutes.
During preset running, if " Start / Stop " key pressed, preset running is paused and washing program
allows user to change the program setting. If " Power " key pressed, the preset running is canceled
and platform is shut down, in this case, user needs to set again the washing program.
Renesas System Solution (Beijing) Co., Ltd, Shanghai Branch
Unit 207 AZIA Center, No.1233 Lujiazui Ring Road, Pudong District, Shanghai, China
Tel: (86-21) 6888-0556
" The second time rinse water "
" The second time rinse water "
" The first time rinse water "
Fax: (86-21) 6888-0559
" The second & third time rinse water "
(no display) " The first time rinse water "
...
Page 24
Zip: 200120
" The third time rinse water "
" The
" The first & second time
...