Operation; Modes Of Operation; Platform Running Mode; Platform Running Status - Renesas R8C Series User Manual

RSSHEUM0003 - 0101
Rev.1.00

3.1 Modes of Operation

As the platform would be used as demo platform or prototype washer in test and validation, we set
two kinds of mode that the platform can run by judging external jumper status.

3.1.1 Platform running mode

The platform runs in modes:
Debugging Mode: In this mode, user can debug the platform s/w and the program running style
is the same with real washer running style except that " J1 " and " J2 " is used as water and
washing status detection.
Demo Mode: In this mode, after " Power " key pressed, the platform runs washer program
automatically and when the program finished the platform will resume and run the same program
again. During automatic program running, user can press "Start/Stop" key to pause the program
and set the program manually, then by pressing "Start/Stop" key, the platform will run user set
program and after user set program finished, the platform will run automatic program again.

3.1.2 Platform running status

In any mode of the platform, the washer program would be in one of below statuses, according to
these statuses, washer s/w run logically to execute washing machine functions.
Stand By: Waiting for " Power " key to turn on the controller; only power LED display are on.
In this mode, the MCU is running.
Initial: The platform is ready for setting by user, by press " Start / Stop " key, the platform will
begin to run user set program.
Stop: During the platform is running program, if " Start / Stop " key pressed, the platform will
turn to " Stop " mode and all output are off.
Run: The platform is running user set program.
Preset: The platform is running in preset mode
Renesas System Solution (Beijing) Co., Ltd, Shanghai Branch
Unit 207 AZIA Center, No.1233 Lujiazui Ring Road, Pudong District, Shanghai, China
Tel: (86-21) 6888-0556

3. Operation

Fax: (86-21) 6888-0559
Page 30
Zip: 200120