Platform Running Status Display Menu; Function Setting Menu Introduction - Renesas R8C Series User Manual

RSSHEUM0003 - 0101
Rev.1.00
1, Preset time setting

2.2.3 Platform running status display menu

This is the fourth level menu of the LCD display structure, and there is only 1 page that displays the
washing program running status and user program setting. In this level menu, only " Start / Stop "
key and " + " key are valid. By pressing " + " key, user can browse the selected program parameters;
by pressing " Start / Stop " key, the program will paused and allows user to set again the washing
program in stop status. The display content is as below by pressing " + " key in 4
" Program left time "
" Function selected "

2.2.4 Function setting menu introduction

This is the menu page for user to set the special function during the washing program running. The
default setting is " No function selected ", by pressing " + " or " - " key user can shift up and down
the available functions from " No function selected " to " All function selected ". Below figure
shows the function selection setting rule.
No function
Renesas System Solution (Beijing) Co., Ltd, Shanghai Branch
Unit 207 AZIA Center, No.1233 Lujiazui Ring Road, Pudong District, Shanghai, China
Tel: (86-21) 6888-0556
" Soak time " " Wash time "
...
Save water
Save water & Tube dry
Fax: (86-21) 6888-0559
2, Running status display
" Rinse time "
Page 25
Zip: 200120
th
level (cycle over):
" Spin time "
Tube dry