User Interface; Platform Key Introduction; Power " Key Introduction - Renesas R8C Series User Manual

RSSHEUM0003 - 0101
Rev.1.00

2.1 Platform key introduction

This part will introduce platform key pressing rule and the LCD display function based on key and
platform running status.
After " Power " key pressed, the platform is in initial mode, all key are valid, and during preset
running, only " + " and " Start / Stop " key are valid. Below table shows the valid and invalid key in
relative program running mode:
Status
Key
" Power "
" Program "
" Function "
" Water Level "
" Start / Stop "
" + "
" - "
" Cancel "
" OK "

2.1.1 " Power " key introduction

When " Power " key pressed, the platform will run in " Initial " mode, all keys are valid for setting
the platform.
The platform will turn to " Stand By " mode if " Start / Stop " key have not been pressed
within 5 minutes since any key pressed (or no key pressed) in this mode.
When the program runs to the end, the platform will run to " Stand By " mode.
Renesas System Solution (Beijing) Co., Ltd, Shanghai Branch
Unit 207 AZIA Center, No.1233 Lujiazui Ring Road, Pudong District, Shanghai, China
Tel: (86-21) 6888-0556

2. User interface

Stand By Initial
○ ○
○
×
○
×
○
×
○
×
○
×
○
×
○
×
○
×
Fax: (86-21) 6888-0559
Run Stop Preset
○ ○
○
×
○
×
○
×
○ ○
○ ○
○
×
○
×
○
×
Page 18
Zip: 200120
Demo/ Debug
Run
○ ○
× ×
× ×
× ×
○ ○
○ ○
× ×
× ×
× ×