Water Level " Key Introduction; Key Introduction; Ok " & " Cancel " Key Introduction; Platform Lcd Display Introduction - Renesas R8C Series User Manual

RSSHEUM0003 - 0101
Rev.1.00

2.1.5 " Water Level " key introduction

When "Water Level" key pressed, the LCD displays the third Level Menu and user can shift the
function selection button by pressing " + " or " – " key. There are 10 levels of water can be selected,
from " 1 " to " 10 ", which increased by pressing " + " key and decreased by pressing " – " key.
During " Soak ", " Wash ", " Rinse " process is running, when " Water Level " key pressed, the inlet
valve will be switched on and Inlet process running, after release " Water Level "key, the Inlet
process stop and valve is switched off. However, if the water level is over protection level, this
function is invalid.
The motor cycle stream will be changed according to the water level setting changed by user. When
" Speedy " program selected, the default water level setting is " 3 " and cannot be changed.
In automatic washing program, the soak time is set by washing software according to the water level
changing; in water level " 1 ", " 2 ", " 3 ", " 4 ", the soak time is 10 minutes; in water level " 5 ",
" 6 ", " 7 ", the soak time is 20 minutes; in water level " 8 ", " 9 ", " 10 ", the soak time is 30
minutes.
Usually, the rinse water level is one level higher than wash water level, but if water level 10 selected,
the rinse water level use the setting value.
2.1.6 " + " & " - " key introduction
User can shift the program or parameter setting button by pressing " + " or " - " key in relative level
of the display menu, the highlighted items on LCD will roll over accordingly.
2.1.7 " OK " & " Cancel " key introduction
When " OK " key pressed, the selected program or parameter is set (on LCD, it's the highlighted
item), and the LCD menu display changed to the next level, and when the " Cancel " key pressed,
the LCD menu level change back to the above level and allow user to re-select the program or
parameter that have already been set.

2.2 Platform LCD display introduction

The platform LCD display have 4 levels of menu as described in the first part of this document, and
there are many buttons in each of these menus, which can be highlighted by shifting the " + " or " - "
key, then by pressing the " OK " key, user can select the dedicated function or the available
parameters in current menu.
Renesas System Solution (Beijing) Co., Ltd, Shanghai Branch
Unit 207 AZIA Center, No.1233 Lujiazui Ring Road, Pudong District, Shanghai, China
Tel: (86-21) 6888-0556 Fax: (86-21) 6888-0559
Page 20
Zip: 200120