Table of Contents
Advertisement
Installation
!
WARNING
!
WARNING
NOTES
Locate the analyzer as close to the sample source as possible and proceed as follows.
1. Remove wiring box cover.
2. Open the shutoff valve and purge the sample source line(s) to an appropriate
Figure 4: Model 2850 Moisture Analyzer Rear Panel Connections
RS-485 Connections (item # 6 in Figure 4) - Do not Connect or Disconnect when
energised
Consult plant safety personnel for appropriate exhaust venting guidelines for specific
sample gas type.
For Division 2 installations, all switches, circuit breakers, relays, and alarms must be
in accordance with NEC 501-3.
Numbers appearing in parentheses correspond to find numbers called out in Table I
and Figure 4.
area for at least 5 minutes. This will help prevent contamination from entering
the analyzer cell. Close the shutoff valve on the sample source line(s).
Installation and Startup 3-5
Advertisement
Table of Contents
