Chapter 3 Installation And Start-Up; Analyzer Location - Ametek Thermox CEM/O2 User Manual

INSTALLATION AND START-UP

NOTE

Analyzer Location

Observe the following guidelines when selecting an analyzer installation
location:
1. Select a readily accessible position for the analyzer to allow for routine
maintenance. Comfort levels for maintenance personnel should be
considered in placement of the sensor and control interface.
2. The installation location should be free from excessive vibration and
the ambient temperature is required to be within the limits listed in
the specifications. If the ambient temperature is outside the speci-
fied limits or the vibration is excessive, please contact Thermox Sales
or Service Department at (412) 828-9040. We have special options to
address ambient temperatures outside the listed specifications and we
can provide special mounting solutions for excessive vibration installa-
tion locations.
The operations in this chapter should be performed only by qualified
service personnel experienced in electrical safety techniques. There
are no operator-serviceable components inside the CEM O2 system.
Never service the controller or sensor unless power has been removed
from the controller and sensor, and the sensor has been allowed to
cool for at least one hour. Also, always use gloves when working on the
sensor.
Installation and Start-up
|
3-1