Connecting The Power Cable - Yamaha RX RX-Z7 Owner's Manual

Connections
(U.S.A. model)
Connecting the wire of the AM loop antenna
Insert
Press and hold
y
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
30
En

Connecting the power cable

■ Connecting the AC power cable
Plug the supplied AC power cable into the AC inlet after
all other connections are complete, then plug the AC
power cable into an AC wall outlet.
Release
■ AC OUTLET(S) (SWITCHED)
U.S.A. and Australia models ................................. 1 outlet
Canada model ....................................................... 2 outlets
Use these outlet(s) to supply power to any connected
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when this unit is turned on. However, power to
these outlet(s) is cut off when this unit is turned off. For
information on the maximum power or the total power
consumption of the components that can be connected to
these outlet(s), see "Specifications" (page 154).
Note
The rated power of the component (such as a subwoofer)
connected to these outlet(s) cannot exceed the maximum power
supplied by this unit.
AC IN
To the AC wall outlet
AC OUTLETS
SWITCHED