Using The Zone Osd - Yamaha RX RX-Z7 Owner's Manual

Using multi-zone configuration
Notes
• When you use the external amplifiers in Zone 2 or Zone 3,
J VOLUME +/– can be used only when "Zone2 Volume" or
"Zone3 Volume" is set to "Variable" (page 103).
• You cannot adjust the volume level of Zone 4 with the controls
on this unit. Use controls on the Zone 4 component to adjust it.
■ Adjusting the front speaker balance of
Zone 2 or Zone 3
Press DTONE CONTROL repeatedly to select
"BALANCE" and then rotate the MPROGRAM
selector for adjustment.
■ Adjusting the tonal quality of Zone 2 or
Zone 3
Note
You cannot adjust the front speaker balance of Zone 4 with the
controls on this unit. Use controls on the Zone 4 component to
adjust it.
Press DTONE CONTROL repeatedly to select
the high-frequency response (TREBLE) or the
low-frequency response (BASS) and then rotate
the MPROGRAM selector for adjustment.
Control range: –10.0 dB to +10.0 dB
■ Setting the sleep timer for Zone 2, Zone
3 or Zone 4
Use this feature to turn of the desired zone after a certain
amount of time.
Set the operation mode to FAMP and then press
CSLEEP repeatedly to set the amount of time.
The sleep timer setting changes as shown below.
120min.
OFF

■ Using the zone OSD

You can display the FM/AM radio, XM Satellite Radio
(U.S.A. and Canada models only), or HD Radio
information (U.S.A. model only) in the video monitor
connected to the ZONE VIDEO jacks. You can also
browse music contents (such as iPod contents) by using
the zone OSD.
1
Set the operation mode selector to FAMP
and then press the desired input selector
button (3).
2
Press KDISPLAY to display the menu
screen on the zone OSD.
128
En
90min.
30min. 60min.
3
Use 9k / n / l / h and 9ENTER to
navigate the menu on the zone OSD.
Notes
• The menu displayed in the zone OSD appears in English
even if Japanese or Russian is selected.
• There are some characters that cannot be displayed in the
front panel display or in the OSD of this unit. Those
characters are replaced with underscores "_".
y
• You can select the zone(s) of which the operational status
is displayed (page 104).
• You can operate the zone OSD in the same way as GUI
operations.