Changing Source Names In The Display Window - Yamaha RX RX-Z7 Owner's Manual

Press G SETUP again to exit from the setup
7
menu.
Notes
• "ERROR" appears in the display window (4) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
• This remote control can learn approximately 200 functions.
However, depending on the signals learned, "FULL" may
appear in the display before you program 200 functions. In this
case, clear unnecessary programmed functions to make room
for further learning (page 122).
• Learning may not be possible in the following cases:
– when the batteries in the remote control for this unit or other
components are weak.
– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or
uncommon.
Changing source names in the
display window
You can change the name of the control area (input
source) that appears in the display window (4) on the
remote control.
1
Set the operation mode selector to
FSOURCE and then press an input selector
button (3) to select the desired control area.
2
Press GSETUP using a ballpoint pen or
similar object.
"SETUP" appears in the display window.
3
Press 9k / n repeatedly to select "RNAME"
and then press 9ENTER.
4
Press 9k / n repeatedly to select 3-letter
name or 5-lettered name you want to edit and
then press 9ENTER.
Each control area has both 3-letter name and 5-letter
name. You can rename the 3-letter name and 5-letter
name independently.
3-letter name
BD
5
6
7
Note
"ERROR" appears in the display window (4) on the remote
control if you press a button not indicated in the respective step,
or when you press more than one button simultaneously.
5-letter name
BD/HD
Edit the name of the control area.
To locate the position to edit, press 9l / h.
To select a character, press 9k / n.
BD/HD
y
Press 9k to change the character in the following order,
or press 9n to go in the reverse order: A to Z, a to z,
0 to 9, space, symbols (–, +, /, :).
Press 9ENTER to set the new name.
"OK" appears in the display window (4) on the
remote control if renaming was successful.
y
When you want to rename the another control area, press
the input selector button (3) or 5SELECT l / h
repeatedly to select the desired control area and then press
9ENTER and then carry out the operations of steps 4
through 6.
Press G SETUP again to exit from the setup
menu.
Remote control features
119
En